Savin SLP20 Wartungshandbuch PDF herunterladen (Seite 256)

USING AN IC CARD

G031/G032 A-8 SM

1.3 USING AN IC CARD

1.3.1 PREPARING THE IC CARD

Two Methods

There are two ways to do this:

• Swapbox

• Copy to an IC card plugged into the printer, from a PC via a parallel cable

The Swapbox method is covered in a separate manual. In this appendix, we will

concentrate on the second method.

If there is any firmware already on the IC card, it will be overwritten.

Preparation

In summary, the procedure is as follows:

1. Make a byte-swapped file of the firmware file on a PC.

• Use the Byte Swap button in the Stinger Service Utility.

2. Copy this file from the PC to an IC card plugged into a G031 or G032 printer,

via a parallel cable.

• The computer must be connected to the printer with a parallel cable.

• The IC card must be connected to the IC card adapter before being plugged

into the printer.

• Use either the Stinger Service Utility (for use with Windows systems) or MS-

DOS (use the ‘copy /b’ command).

NOTE: When using the Windows utility, all Windows utility files must be copied to

the same directory.

When using MS-DOS, download the download.hed file first (supplied with

the Stinger Service Utility), then download the controller firmware file.

CÓPIA NÃO CONTROLADA

1 2 ... 251 252 253 254 255 256 257 258 259 260 261 ... 273 274

Keine Kommentare

Savin SLP20 Wartungshandbuch Seite 256